Applying Microne Medium with Terrazzo Flakes

Mixing the Microne Medium with Terrazzo Flakes

You will need 20kg of Microne Medium with Terrazzo to complete 1 coat over 10m2.

Then add 1kg Terrazzo Flakes to 10kg Microne Medium & mix gently on a slow speed. Take care not to mix too aggressively as this could cause theTerrazzo to break down.

Applying the Microne Medium with Terrazzo

Use a Microcement Trowel and hold hold it quite flat to the surface. Don’t put as much pressure on as you did with the base coats to avoid crushing the flakes.

Gently spread the terrazzo across the area so that you have full coverage.

Leave to Dry

Leave the Microcement to dry. This should take around 12 hours. Drying times do vary depending on temperature and ventilation.

Sand with 40, 80 & 120 Grit Silicone Carbide Sand Paper

Sand with 40 grit sand paper to reveal the terrazzo in the microcement.  This will be a lot easier with an orbital sander than by hand.

Once you have revealed a good, even spread of terrazzo, move onto the 80 grit sand paper and give the whole area another sand.

Finally, use a 120 grit sand paper to tidy up your wark and close in the pours.

Vacuum the surface to remove all dust and debris. Do not wet the microcement.

We stock a range of Microcement Sanding Discs on our website.